Tighten the tensioner screw until the chain does not sag from the underside of the bar, but can still be pulled away about 1/8" (3mm) by hand.
The Model 40268 is designed to act as a second set of hands. Once clamped, the rubberized pads (check yours for wear and tear—replacing them improves grip) should hold the wood firmly, allowing you to make your cuts or drill your holes without the workpiece sliding. woodzig model 40268 manual
Owen’s apartment was silent. Then, from the kitchen—a low hum. Not the fridge. Not the furnace. A single, sustained note. C. Or maybe C-sharp. Tighten the tensioner screw until the chain does
Lost your printed copy? The official is available in several places: Owen’s apartment was silent
The refers to calibration as the “secret to joinery-grade accuracy.” Perform these three calibrations monthly: