Sinotimer Mc101 Manual -

Here are the most common problems reported by Sinotimer MC101 users and the solutions found in the official manual.

To ensure accurate readings, you must match the controller to your sensor. sinotimer mc101 manual

If the controller reads "EEEE" or an impossible temperature, go into the settings (Cod=0000) and ensure the input type matches your sensor (e.g., set to "K" for K-type). Celsius vs. Fahrenheit: Here are the most common problems reported by

is built for accuracy and broad compatibility with common industrial sensors: Measurement Accuracy: 0.3% of the full scale. Resolution: for thermocouples and thermal resistance (RTD) inputs. for analog signals. Celsius vs

Supports thermocouples (K, J, E, S, etc.) and thermal resistance (Pt100). Control Output: Relay Output: For driving contactors. SSR Output: DC voltage signal to drive a Solid State Relay. 🛠️ Advanced Parameter Settings To enter the internal menu, press and hold the key for about 3 seconds. Description Proportional Band Adjusts the range of the proportional control. Integral Time Corrects for long-term offset. Derivative Time Responds to the rate of change to prevent overshoot. Alarm Values Sets the threshold for triggering alarm relays. Sensor Calibration Offsets the display if the sensor reading is slightly off. ⚠️ Troubleshooting Tips Display says "ORAL":