Manual ((exclusive)) | Xmtk-9000 User

The XMTK-9000 uses a card-based UI. Swipe down from the top for the :

| Parameter | Value | |--------------------|--------------------------------| | Analog inputs | 12 (16-bit resolution) | | Accuracy | ±0.1% of full scale | | Digital outputs | 6 (relay, 3A @ 250V AC max) | | Communication | RS-485, Ethernet (optional) | | Operating temp | -10°C to +55°C | | Storage temp | -20°C to +70°C | | Dimensions (WxHxD) | 108 x 90 x 60 mm | | Weight | 320 g | xmtk-9000 user manual

Full 24-page wiring appendix available online. The XMTK-9000 uses a card-based UI

| Error | Meaning | Corrective Action | |-------|---------|--------------------| | E-01 | Sensor open (thermocouple or RTD) | Check wiring continuity. Simulate input with calibrator. | | E-04 | Input signal below range (<3.8 mA on 4-20 mA input) | Verify transmitter power (24 VDC loop). | | E-12 | EEPROM checksum failure | Cycle power. If persists, reload firmware via USB. | | E-47 | Auto-tune oscillation unrecognized | Increase system damping or run AT at lower setpoint. | | E-91 | Modbus CRC timeout | Check serial cable; verify baud rate matches host. | Simulate input with calibrator