Manual Link | Crawford Cdm9 950 Installation

: The control box contains a "manoeuvring card" for cable connections and status LEDs (indicating stop circuit and limit switch status). 3. Initialization & Programming (Setup)

Use the manual controls to jog the door and check the direction of rotation. Automatic test: Run a full open and close cycle. crawford cdm9 950 installation manual

This guide breaks down the essential steps for a successful setup, referencing key procedures found in the official Crawford/ASSA ABLOY manual . : The control box contains a "manoeuvring card"

This article serves as a comprehensive companion to that manual. We will break down the installation process into digestible stages, highlight common pitfalls, and explain why following the manufacturer’s guidelines to the letter ensures longevity and performance. Automatic test: Run a full open and close cycle

The drive unit should be installed at a height of at least above the floor. Follow these steps for the mechanical assembly:

Before starting, disengage the door and place it approximately 1.5 meters above the floor, then re-engage it.

If the motor is non-responsive, check the X4 and X5 contacts in the control box lid and verify that the operator is not disengaged.