Indicates high or low-temperature alarm conditions. AT: Flashes during the auto-tuning process.
To access the full configuration menu, until you see the first parameter code. Navigate using ◄ (scroll through codes) and ▲/▼ (change value). Press SET to save a parameter and move to the next. xta-7000 temperature controller manual
Flashes when the Auto-tuning function is active. 4. Programming and Parameter Setup Setting the Target Temperature (SV) Indicates high or low-temperature alarm conditions
With the manual propped open against a pipe, Elias followed the guide. He stripped the wire with his teeth, the copper tasting like pennies and desperation. He slotted it back into the terminal and tightened the screw until his knuckles went white. He hit the RESET toggle. Navigate using ◄ (scroll through codes) and ▲/▼
Relay (5A/240V AC), SSR Drive (12V-15V pulse), or Current (4–20mA). Environment: Operates between 0°C to 50°C with humidity below 85% RH. Physical Size: The XTA-7000 typically has a front panel with a Toolots, Inc. 2. Panel Indicators & Buttons PV Display: Shows the current measured Process Value (Red LED). SV Display: Shows the Target/Setting Value (Green LED). Used to enter the menu, switch modes, and save new values. Data Shift Key (Left Arrow): Shifts the active digit for faster adjustment. Up/Down Keys: Used to increase or decrease numeric values. Indicators: (heating active), (alarms active), and (auto-tuning in progress). 3. Basic Operation Guide Setting the Target Temperature (SV): key briefly. The SV display will begin to flash. keys to reach your desired temperature. again to confirm and save the value. Activating Auto-Tuning (AT):
Relay Contact, SSR Drive (Voltage Pulse), or 4-20mA Analog. Power Supply: 85–265V AC, 50/60Hz. 2. Terminal Wiring Diagram