Rf300 Installation Manual — Simrad

: Do not remove the transmitter arm from the feedback unit, as it is factory adjusted. Set the transmitter rod to the inner limit of the outer slot as a starting point.

The unit connects directly to the rudder feedback terminals on your Simrad Autopilot Computer (such as the AC12 or AC42). simrad rf300 installation manual

: Connect the two wires to the dedicated "Rudder Feedback" terminals on your Simrad junction box (e.g., J300X, AC10, AC20, or AC42). Brown Wire : Do not remove the transmitter arm from

Attach the transmitter rod to the ball joint only after both the rudder and the RF300 are centered. Pre-adjusted Arm : Connect the two wires to the dedicated

: Set the rudder to the center position. Rotate the RF300 transmitter lever until the alignment marks match, then attach the transmitter rod.

Ensure the cable is clamped to allow for full rudder movement and include a "drip loop" to prevent water from following the cable into the unit. 3. Calibration and Testing